| ¡@ |
|
The
X600 mono block amplifier has only two gain stages: a single stage front
end that provides all the voltage gain, and a high current follower
stage. The X600 utilizes the same faceplate, meter, and front-end
circuitry as in the larger X1000. It has a proportionately smaller power
supply and output stage. The X600 delivers 600 watts into an 8-ohm load
and 1200 watts into 4 ohms. The X600 only accepts balanced inputs,
demanding balanced operation to obtain the highest performance possible.
The
very high bias of the X600 allows a tremendous amount of pure Class A
wattage to be delivered from the output stage. This translates into an
amplifier that is both intimate and involving, expressing fine and
discriminating detail, as well as one that instantaneously responds to
challenging musical passages and transients with total control and
seamless integration. The extended frequency range and dynamic
characteristics of the X600 have led it to be the go-to amplifier for
several global manufacturers in demonstration systems of their
cutting-edge source components.
| Gain |
30dB |
| Freq.
Response |
-0
dB at DC, -3 dB at 100 kHz |
| Power
Output |
600
watts maximum @ 1% THD, 1 kHz, 8 ohms |
| Output
Voltage |
Maximum
plus, minus approx. 105 volts |
| Output
Current |
Maximum
plus, minus approx. 25amps |
| Input
Impedance |
22
kohm balanced |
| Damping
factor |
60
ref 8 ohms nominal |
| Slew
rate |
approx.
plus, minus 40 V/uS |
| Output
Noise |
approx.
500 uV unweighted 20-20 kHz |
| Random
noise floor |
approximately
2 uV |
| Dynamic
range |
153
dB (random noise floor to peak output) |
| Balanced
CMRR |
approx.
-85 dB @ 1 kHz (input common mode rejection ratio) |
| DC
offset |
<
100 mv |
| Power
Consumption |
approx.
600 watts idle, 1800 max |
| Dimensions |
19"W
x 11"H x 22"D |
| Weight |
150lbs |
|
